Title: Build the Coil Winding
Objective: Process & Steps to make coil winding.
Content/Procedure:
After making a calculation to get 10V on coil by
determining the resistance of the each coil of 200ohm.
This are neodyminium strong magnet which is rare earth
magnet.
After completing each coils with resistance of 200 ohms, which is included with each magnet and nylon belt and I make the installation on this panel.
Result: The figure below shows the results of which are installed on a test panel to be tested before it is mounted on a steel panel.
Conclusion: There are several difficult things need to
tested when I have build this project frame but finally it successful finish.
No comments:
Post a Comment